1 When the production uses 1.0 to 2.0 abrasives, there are operators who often do not operate in place, and the abrasives burst. Sometimes the cutter is broken or the fibers are too much to make the cutter inconveniently cut down to stop cutting the cutter. Sometimes the operator quickly adjusts the cutter for the convenience of the diagram, and then restarts the startup without removing the abrasive cleaner.
Here, it is emphasized that in the case of grinding tools with 2.0 or less, the grinding tools must be dismantled when they are stopped.
In the production of the following 2.0 should be good to measure the humidity of the conditioning material before entering the cavity. If the dryness and humidity of the material powder are not in place, it is very easy to cause the current to rise and the grinding tool to stop grinding. In these cases, it is easy to blow up the grinding tool in a very short time.
Give you a small trick here: In the production of 2.0 or less grinding tools, when the material from the conditioner into the cavity, you can open the washing machine a little to maintain the humidity of the material, let it reduce the current, as long as the material from When the grinding tool hole comes out, you can turn off the washing machine immediately or just open it and turn it off immediately. [Be careful not to add too much water].
In the production of more than 5.0 of the abrasive, in the replacement of the knife or the need to dismantle grinding tools, shutdown can open the washing machine to maintain the moisture of the grinder and cavity, so that you can directly restart without dismantling grinding tools. Do not exceed 10 minutes.
Vitamin B1 Hcl,Vitamin D3 Oil,Vitamin D3 Powder,Bulk Vitamin E Powder
Ningbo Nutrition Food Technology Co.,ltd. , https://www.collagenworkshop.com