First, the characteristics of the paste filling machine
1, the new horizontal design, light and convenient, automatic pumping, for the thicker paste can be added to the hopper.
2, manual and automatic mutual switching function: when the machine is in the "automatic" state, the machine presses the set speed,
3. Automatic continuous filling. When the machine is in the "manual" state, the operator steps on the pedal to achieve the filling. If it is kept on, it will also become the state of automatic continuous filling.
4. Anti-drip filling system: When the filling is done, the cylinder moves up and down to drive the bulkhead. When the cylinder moves upwards, the bulkhead is upward, that is, the valve is opened, and the material is started to be filled; otherwise, the filling is stopped. And to prevent the phenomenon of dripping and drawing.
5. The material cylinder and the three-way part are connected by hand, without any special tools, and the loading and unloading cleaning is very convenient.
Second, paste filling machine cleaning, operation and maintenance
Thoroughly clean before use, wipe off oil or dirt with a soft cloth and detergent, and then dry with a soft cloth. In accordance with GMP requirements, check whether the contact parts of the equipment and materials meet the corresponding cleanliness requirements. If not, re-clean the ear and listen to dryness. The cleaning method is based on the process requirements.
1. The filling action of the machine is divided into automatic and manual. When the height is machined, when manual is used, only need to use the bottle mouth to push the contact tongue, then start sucking. Do not hold the contact tongue when filling. When automatic is used, the bottle must be placed under the discharge port. When the transfer switch is turned on, the filling will start immediately and the bottle will be replaced in time.
2. When it is found that the metering is unstable during filling, it should be checked that the feed check valve may be caught by debris, resulting in a tight seal and affecting the filling amount.
3. Leakage of the lower part of the cylinder indicates that the piston seal is worn and the seal is required to be replaced.
Third, the paste filling machine installation and commissioning
1. After the machine is unpacked, install it according to the “Installation Diagram†and connect the compressed air source. The pressure of the air source is 0.6MPa. If the main pipe of the compressed air is connected, the valve should be installed first.
2. Open the right door and screw out the oil mister oil mark to add clean special oil, or sewing machine oil. Note: You can't carry air pressure when refueling, and the oil quantity should be increased to 8 points.
3. Check the air supply to check whether the sealing surfaces are leaking. Adjust the air pressure to 0.3~0.4MPa to adjust the oil input. After a few movements, spray a drop of oil and check the fuel injection regularly.
4, filling volume adjustment: first rotate the filling volume to adjust the hand wheel, observe the indicator window scale, so as to achieve the required loading, while adjusting the suction and discharge speed to achieve a satisfactory filling effect, the amount of measurement filling Quantity, and finally correct the filling amount.
Weight Loss Patch,Slimming Patch,Slim Leg Patch
GUANGZHOU XIANGGUO BIO-TECHNOLOGY CO., LTD. , http://www.slimmanufacturer.com