The use of an indoor framework for the cultivation of oyster mushrooms usually produces mushrooms only on the front of the bed, and its production capacity has not been fully utilized. For example, in the frame-shaped mushroom bed, producing both the positive and negative sides of mushrooms simultaneously can produce 15.5 kilograms of mushroom per square meter on the basis of no increase in the formulation of the culture material per unit area and the number of strains broadcasted, and 7.6 kilograms of the yield of the opposite mushroom. Only in the positive growth of mushroom production nearly doubled, and early fruiting can be about 7 days. Here are the key points for the production of mushrooms on both sides of the mushroom mushroom bed:
Mushroom frame structure is set in the indoor use of bamboo or standing wood to build the framework, fixed on the frame mushroom bed floor, the frame is generally 2 meters high, set up three layers of mushroom bed, the distance between the layers of 60 to 65 cm; mushroom bed width in two ways, The width of the bilateral management is 110 cm, and the width of the unilateral management is 55 cm. The bottom of the mushroom bed is made by thin wood nails, and the distance between each bar is 1.5 to 2.0 cm.
Sowing cultivation strains select "Florida" with a wide range of suitable temperature. Seeding is done by layering. The specific operation is as follows: First, a layer of plastic film is laid on the bottom of the mushroom bed, and its width is 2.5 times the width of the base of the mushroom bed. Then the first layer of mushroom culture material is spread on the plastic film, and the thickness is about 3 cm; The first layer of Pleurotus ostreatus culture material was sprinkled with the first layer of bacteria, spreading a total of four layers of culture material and three layers of bacteria. After compaction, the surface of the culture material is covered with a wet newspaper that has been wetted with water, and finally the whole culture medium is tightly wrapped with a plastic film.
After 60 days of mushroom inoculation, the mycelia feed was almost completed. At this time, the plastic film was intermittently cut along the length of the bottom of the mushroom bed with a blade at the bottom of the bottom of the mushroom bed until the medium. The length of each section of the slit shall not exceed 15 cm, and the horizontal and vertical spacing between the slits shall be greater than 15 cm. After each spraying of water on the mushroom bed, sprayers are used to spray water on the opposite side of the mushroom bed, and the rest of the management is the same as conventional. After the first oyster mushroom on the opposite side of the mushroom bed is harvested, the knife can be used to cut open the plastic film that has not been drawn on the back surface of the mushroom bed. Throughout the cultivation process, the oyster mushroom on the opposite side of the mushroom bed can pick 2 to 3 oysters. The yield is close to the output of the mushroom bed.
HEBEI PINGLE FLOUR MACHINERY GROUP CO., LTD , https://www.plrollermill.com