Ten methods commonly used for repairing agricultural machinery

1. The bent tubing copper tubing is made of hard material, so it is inconvenient to be bent. You can use the charcoal to burn red in the area you want to bend. Immediately put it in water to cool it and it will become soft and easy to bend. 2, iron filter decontamination air filter iron filter, it is difficult to wash with diesel, if the filter is stained with diesel, can be ignited and burned, after the fire is extinguished, tapping the core with a wooden stick, so that fireworks fall off Can completely remove the filter inside and outside the dirt. 3. When the piston ring is not elastic enough, a standard new ring of the same type can be used, and the old ring to be inspected is placed vertically along the circumference and the opening of both rings is in a horizontal position. Then press the two rings by hand. If the opening of the new ring moves, the opening of the old ring has been closed, indicating that the old ring is flexible and can continue to be used. 4, row engine oil pump air. For the S195 diesel engine rotor oil pump, if the pump air is not drained, there will be failure to pump oil. The trick is to use a medical waste needle to fill up the oil, fill it into the pump inlet, and turn the oil pump to make the outlet out of the oil. 5. The connection between the nose of the high pressure oil pipe and the injector and the oil valve is maintained by the machining accuracy of the contact surface and the fastening force of the pipe nut. Once the contact surface is worn out and leaks oil, a round copper skin can be cut from the waste cylinder pad, and a small hole can be strung in the middle and can be placed between the convex head and the concave pit. 6. Repair the broken paper mat, apply a little butter on both sides of the paper pad, and then cut two thin white papers of the same size as the paper pad, stick them on both sides of the paper pad, and put them on the machine. Tighten the nuts to eliminate the leakage. 7, rule the slow leak of tires Take two tablespoons of talcum powder, pull down the valve core, put up the air inside the tire, use a stiff paper made funnel to insert the valve, the talcum powder poured into the inner tube. When the irrigation is not in progress, the paper cow can be taken off. Turn the wheel and then fill it until it is finished. Then fill the valve core with enough air. After inflated, talcum powder is dispersed in the fetus and diffusely attached to the inner wall of the femur, which can stop tiny air holes from spreading. 8, in addition to scale. Put two larger peeled, seeded loofahs, rinse them into a water tank, and replace them regularly. 9. Remove the deceleration gear outer elastic retaining ring. The Dongfeng--12 hand drags the outer elastic retaining ring of the reduction gear in the transmission, and it is very difficult to disassemble. At this time with a wire, one end through the small hole in the ring after the tightening, the other end with a screwdriver wound, tightly pull, and then rotate the drive wheel back and forth a few times, the ring can be removed. 10. In addition to dirt in the fine filter. The dirt and dirt in the rotor oil filter cannot be easily removed. If a layer of paper is applied to the inner wall of the rotor with butter, and the soil is attached to the paper, the paper can be removed and the soil can be completely removed.

Jojoba Oil

Jojoba Oil,High Quality Jojoba Oil,Jojoba Oil Details, Shaanxi Tai Ma Health Biological Co., Ltd.

Ningxia Rich Resource International Co., Ltd , http://www.richresources-nx.com

Posted on